When an internal malfunction occurs in the ID code box (immobiliser code ECU), the certification ECU (smart key ECU assembly) stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B2790 | An internal malfunction occurs in the ID code box (immobiliser code ECU) (EEPROM access malfunction) (1 trip detection logic*1). | ·
ID code box (immobiliser code ECU) ·
Certification ECU (smart key ECU assembly) |
An immobiliser set/unset operation is performed (Turn the power switch is off or on (IG) while carrying the key). |
*1: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
·
READY ON: Hybrid control system cannot be started next time ·
Hybrid control system stopped: Hybrid control system cannot be started |
- |
| DTC Code | Data List and Active Test |
|---|---|
| B2790 | - |
Before replacing the certification ECU (smart key ECU assembly) or ID code box (immobiliser code ECU), refer to Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
Replace the ID code box (immobiliser code ECU).
Refer to Service Bulletin.
NEXT
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Register the recognition codes in the ECUs.
Refer to Service Bulletin.
NEXT
Register the ECU communication ID.
Refer to Service Bulletin.
NEXT
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC B2790 is not output.
OK
NG