The intrusion sensor (theft warning ultrasonic sensor) (map light assembly) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).
If a problem is detected in the signals transmitted and received by the intrusion sensor (theft warning ultrasonic sensor) (map light assembly), or if the transmission or reception circuits malfunction, the intrusion sensor (theft warning ultrasonic sensor) (map light assembly) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2761 | Intrusion sensor outputs signal for sensor malfunction | ·
Intrusion sensor (theft warning ultrasonic sensor) (map light assembly) ·
Main body ECU (multiplex network body ECU) |
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR).
Turn the power switch on (IG), then off.
Set the theft deterrent system to "ARMED STATE".
Check that the security indicator changes from illuminated to blinking.
Set the theft deterrent system to "DISARMED STATE".
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR).
DTC B2761 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the intrusion sensor (theft warning ultrasonic sensor) (map light assembly) (See page Vehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL).
NEXT
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR).
Turn the power switch on (IG), then off.
Set the theft deterrent system to "ARMED STATE".
Check that the security indicator changes from illuminated to blinking.
Set the theft deterrent system to "DISARMED STATE".
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>DTC CHECK / CLEAR).
DTC B2761 is not output.
OK
NG