Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.DISCONNECT ROOF HEADLINING ASSEMBLY
81340
2.REMOVE VANITY LIGHT ASSEMBLY
Tilt the tab to disengage the 2 claws <A> and separate the bulb holder from the vanity light as shown in the illustration.
| *1 | Claw <A> |
| *2 | Claw <B> |
| *3 | Bulb Holder |
| *4 | Tab |
Disengage the claw <B> and remove the vanity light assembly.