81260A
1.INSPECT MAP LIGHT ASSEMBLY
Inspect the interior light operation.
Connect a positive (+) lead from the auxiliary battery to terminal 11 (+B1) and a negative (-) lead to terminal 15 (GND1) or 6 (CTY).
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 11 (+B1) - 15 (GND1) - 6 (CTY)*1 | Interior light door switch OFF and personal light switch OFF | Personal light LH and RH do not come on |
| Interior light door switch OFF and personal light switch LH ON | Personal light LH comes on | |
| Interior light door switch OFF and personal light switch RH ON | Personal light RH comes on | |
| Interior light door switch ON and personal light switches OFF | Personal light LH and RH come on | |
| Interior light door switch DOOR and personal light switches OFF | Personal light LH and RH come on | |
| 11 (+B1) - 15 (GND1) - 16 (CTY)*2 | Interior light door switch OFF and personal light switch OFF | Personal light LH and RH do not come on |
| Interior light door switch OFF and personal light switch LH ON | Personal light LH comes on | |
| Interior light door switch OFF and personal light switch RH ON | Personal light RH comes on | |
| Interior light door switch ON and personal light switches OFF | Personal light LH and RH come on | |
| Interior light door switch DOOR and personal light switches OFF | Personal light LH and RH come on |
*1: for LHD
*2: for RHD
If the result is not as specified, replace the bulb or map light assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (B) - 11 (+B1) | Always | Below 1 Ω |
| 15 (GND1) - 10 (E) | Always | Below 1 Ω |
| 6 (CTY) - 7 (DCTY)*1 | Interior light door switch ON or OFF | 10 kΩ or higher |
| Interior light door switch DOOR | Below 1 Ω | |
| 16 (CTY) - 7 (DCTY)*2 | Interior light door switch ON or OFF | 10 kΩ or higher |
| Interior light door switch DOOR | Below 1 Ω | |
| 15 (GND1) - 7 (DCTY) | Interior light door switch DOOR or OFF | 10 kΩ or higher |
| Interior light door switch ON | Below 1 Ω |
*1: for LHD
*2: for RHD
If the result is not as specified, replace the map light assembly.
| *a | Component without harness connected
(Map Light Assembly) |
| *A | for LHD |
| *B | for RHD |