Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301792 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Entire Combination Meter does not Operate  


DESCRIPTION

This circuit is the power source circuit for the meter. This circuit provides two types of power sources; one is a constant power source, and the other is an IG power source.

WIRING DIAGRAM

E143732E51
5.023,5.019 7.149,5.341 2.127,0.323 10 Combination Meter Sub-assembly (Meter Circuit Plate) 6.163,1.294 6.446,1.452 0.283,0.158 10 B 6.163,2.282 6.546,2.440 0.383,0.158 10 IG+ 6.163,3.273 6.400,3.431 0.237,0.158 10 ES 5.975,1.175 6.154,1.333 0.178,0.158 10 1 5.975,2.163 6.154,2.321 0.178,0.158 10 2 5.023,4.878 5.305,5.035 0.283,0.158 10 L27 5.916,3.161 6.094,3.319 0.178,0.158 10 11 3.586,2.406 3.909,2.701 0.323,0.295 10 MET 4.641,1.411 5.109,1.560 0.468,0.149 10 ECU-B 1.748,1.272 3.109,1.421 1.361,0.149 10 from Auxiliary Battery 0.166,2.273 1.268,2.422 1.102,0.149 10 from IG2 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses of circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (COMBINATION METER SUB-ASSEMBLY CIRCUIT)
a.
U155023E01
0.198,0.162 0.378,0.325 0.179,0.163 10 *a 0.841,1.315 1.139,1.496 0.298,0.181 10 L27 0.419,1.616 0.670,1.795 0.251,0.178 10 IG+ 0.242,1.98 0.364,2.159 0.122,0.178 10 B 0.733,2.354 0.586,1.794 false 0.389,2.099 0.606,2.358 false 2.245,1.408 2.471,1.586 0.225,0.178 10 ES 2.221,1.572 1.804,2.351 false

Disconnect the L27 combination meter sub-assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L27-11 (ES) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L27-2 (IG+) - Body ground Power switch off Below 1 V
Power switch on (IG) 11 to 14 V
L27-1 (B) - Body ground Power switch off 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Combination Meter Sub-assembly)



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR