The combination meter sub-assembly communicates with the power management control ECU, skid control ECU, power steering ECU assembly and airbag ECU assembly via the CAN communication system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0100 | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with power management control ECU continues for 2 seconds or more |
·
Power management control ECU ·
CAN communication system ·
Combination meter sub-assembly (Meter circuit plate) |
| U0129 | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with skid control ECU continues for 3 seconds or more |
·
Skid control ECU ·
CAN communication system ·
Combination meter sub-assembly (Meter circuit plate) |
| U0131 | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with power steering ECU assembly continues for 3 seconds or more |
·
Power steering ECU assembly ·
CAN communication system ·
Combination meter sub-assembly (Meter circuit plate) |
| U0151 | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with airbag ECU assembly continues for 10 seconds or more |
·
Airbag ECU assembly ·
CAN communication system ·
Combination meter sub-assembly (Meter circuit plate) |
Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| DTCs are output. | A |
| DTCs are not output. | B |
A
B
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)