Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301792 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Hybrid System Indicator Malfunction  


DESCRIPTION

A hybrid system indicator is adopted for this vehicle. In this circuit, the combination meter sub-assembly receives the hybrid system indicator level signal from the power management control ECU via the CAN communication line. The combination meter sub-assembly controls the operation of the hybrid system indicator according to the hybrid system indicator level signal received from the power management control ECU via the CAN communication line.

WIRING DIAGRAM

E337681E17
0.083,3.094 1.417,3.49 1.333,0.396 10 false Power Management Control ECU 2.927,3.167 4.781,3.594 1.854,0.427 10 false : CAN Communication Line 5.083,3.094 7.146,3.479 2.063,0.385 10 false Combination Meter Sub-assembly (Meter Circuit Plate)

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).

Result:
Result Proceed to
CAN communication DTCs are not output. A
CAN communication DTCs are output. B




A

2.PERFORM ACTIVE TEST USING GTS (HV SYSTEM INDICATOR)

B

2.PERFORM ACTIVE TEST USING GTS (HV SYSTEM INDICATOR)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Check the indicator light operation according to the values in the table below.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
HV System Indicator Hybrid System Indicator MIN, -50, 0, 100, MAX -

OK:

Hybrid system indicator indication is normal.




OK

3.READ VALUE USING GTS (HYBRID SYSTEM INDICATOR)

NG

3.READ VALUE USING GTS (HYBRID SYSTEM INDICATOR)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Data Test.


e.

Check the values by referring to the table below.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Hybrid System Indicator Hybrid system indicator value/ Min.: -512, Max.: 511 (%) -512 to 511 (%) -

OK:

Hybrid system indicator value displayed on the GTS is almost the same as hybrid system indicator indication.




OK

4.REPLACE METER CIRCUIT PLATE

NG

4.REPLACE METER CIRCUIT PLATE
a.

Replace the meter circuit plate with a new or a known good one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>DISASSEMBLY).

OK:

The operation of the hybrid system indicator returns to normal.




OK

END

NG