1.CUSTOMIZE METER / GAUGE SYSTEM
Customizing with the GTS
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Customize Setting / Combination Meter / Warning, Display.
Select the setting by referring to the table below.
Be sure to record the current value before customizing.
| Tester Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Key Remind Sound | 1200 ms | Function to change the cycle of the key remind warning buzzer | 1200, 900, 600 ms | Combination meter sub-assembly |
| Reverse Buzzer | Continual | Function to change the type of the reverse warning buzzer | Single or Continual | Combination meter sub-assembly |
| Tester Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Language | *1 | Function to change the language of the headup display | Eng US, Eng UK, French, German, Spanish, Italian, Japanese, CHN Sim, CHN Trd, Russia | Combination meter sub-assembly |
*1: Changes according to the vehicle specification
Customizing with the combination meter sub-assembly
Press and hold the DISP switch (steering pad switch assembly) when entering an item.
Briefly press the DISP switch (steering pad switch assembly) when selecting an item.
Turn the power switch on (IG).
Enter the following menus: SET.
Press and hold the DISP switch (steering pad switch assembly).
Select the setting by referring to the table below.
| Combination Meter Sub-assembly Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| SET | All display mode | Function to change the HV system indicator, EV indicator and Eco driving indicator setting | ·
All display mode ·
HV system indicator and EV indicator display mode ·
HV system indicator display mode ·
Display off mode ·
Eco driving indicator display mode |
Combination meter sub-assembly |
Press and hold the DISP switch (steering pad switch assembly).