Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2014.11
RM2070E _58 Vehicle Interior _061940 METER / GAUGE / DISPLAY _0301792 METER / GAUGE SYSTEM A

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  CUSTOMIZE PARAMETERS  


PROCEDURE

Hide 1.CUSTOMIZE METER / GAUGE SYSTEM

a.

Customizing with the GTS

i.

Connect the GTS to the DLC3.


ii.

Turn the power switch on (IG).


iii.

Turn the GTS on.


iv.

Enter the following menus: Customize Setting / Combination Meter / Warning or Display.


v.

Select the setting by referring to the table below.

NOTICE:

Be sure to record the current value before customizing.



Warning
Tester Display Default Content Setting Relevant ECU
Key Remind Sound Normal Function to change the cycle of the key remind warning buzzer Fast, Normal, Slow Combination meter sub-assembly
Reverse Buzzer Continual Function to change the type of the reverse warning buzzer Single or Continual Combination meter sub-assembly

Display
Tester Display Default Content Setting Relevant ECU
ODO Display Time After IG OFF Setting 30s Function to change the ODO Display time after the power switch is turned off OFF, 30s, 60s, 600s Combination meter sub-assembly