1.INSPECT HEADUP DISPLAY SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (NVM) - 1 (E) | HUD SET switch is pressed | 1782 to 1818 Ω |
| HUD SET switch is not pressed | 10 kΩ or higher | |
| HUD tilt up switch is pressed | 811.8 to 828.2 Ω | |
| HUD tilt up switch is not pressed | 10 kΩ or higher | |
| HUD tilt down switch is pressed | 326.7 to 333.3 Ω | |
| HUD tilt down switch is not pressed | 10 kΩ or higher | |
| 4 (CH) - 1 (E) | HUD main switch is pressed | 1782 to 1818 Ω |
| HUD main switch is not pressed | 10 kΩ or higher | |
| HUD rheostat up switch is pressed | 811.8 to 828.2 Ω | |
| HUD rheostat up switch is not pressed | 10 kΩ or higher | |
| HUD rheostat down switch is pressed | 326.7 to 333.3 Ω | |
| HUD rheostat down switch is not pressed | 10 kΩ or higher |
Apply auxiliary battery voltage from the wire harness back side between the terminals of the switch, and check the lighting condition of the headup display switch assembly.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 7 (ILL+)
Auxiliary battery negative (-) → 2 (ILL-) |
Always | Headup display switch assembly illuminates |
| Auxiliary battery positive (+) → 6 (TAIL)
Auxiliary battery negative (-) → 1 (E) |
Always | HUD main switch illuminates |
| *a | Component without harness connected
(Headup Display Switch Assembly) |
If the result is not as specified, replace the headup display switch assembly.