Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301798 AIRBAG SYSTEM J

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  SRS Warning Light does not Come ON  


DESCRIPTION

The SRS warning light is located on the combination meter sub-assembly.

When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the power switch is turned from off on (IG), and then goes off automatically.

If there is a malfunction in the SRS, the SRS warning light comes on to inform the driver of a problem.

When terminals TC and CG of the DLC3 are connected, the DTC is displayed by blinking of the SRS warning light.

The SRS is equipped with a voltage-increase circuit (DC-DC converter) in the airbag ECU assembly in case the source voltage drops.

When the auxiliary battery voltage drops, the voltage-increase circuit (DC-DC converter) functions to increase the voltage of the SRS to normal voltage.

A malfunction in this circuit is not stored in the airbag ECU assembly. The SRS warning light automatically goes off when the source voltage returns to normal.

The signal to illuminate the SRS warning light is transmitted from the airbag ECU assembly to the combination meter sub-assembly through the CAN communication system.

WIRING DIAGRAM

C264459E01
0.164,1.814 1.513,1.952 1.349,0.137 10 from Auxiliary Battery 5.119,0.729 5.405,0.866 0.287,0.137 10 IGN 2.335,1.412 2.716,1.568 0.381,0.156 10 MET 2.269,1.97 2.752,2.124 0.483,0.154 10 ECU-B 3.152,2.373 3.374,2.515 0.222,0.142 10 ES 2.96,1.726 3.057,1.872 0.097,0.147 10 1 2.959,1.15 3.057,1.297 0.098,0.147 10 2 5.806,1.126 5.978,1.273 0.172,0.147 10 13 4.125,1.118 4.297,1.265 0.172,0.147 10 19 2.881,2.268 3.056,2.414 0.175,0.147 10 11 6.081,0.587 6.334,0.734 0.253,0.147 10 IG2 3.609,1.244 4.024,1.390 0.415,0.147 10 CANH 3.615,1.834 4.025,1.981 0.410,0.147 10 CANL 6.081,2.362 6.276,2.509 0.195,0.147 10 E1 6.081,2.876 6.276,3.022 0.195,0.147 10 E2 6.041,3.656 6.384,3.802 0.343,0.147 10 L16 2.996,3.642 3.334,3.788 0.338,0.147 10 L27 6.036,3.798 6.836,4.114 0.799,0.316 10 Airbag ECU Assembly 2.996,3.812 5.157,4.179 2.161,0.367 10 Combination Meter Sub-assembly (Meter Circuit Plate) 5.806,1.672 5.978,1.819 0.172,0.147 10 22 6.081,1.255 6.496,1.402 0.415,0.147 10 CANH 6.081,1.811 6.500,1.958 0.420,0.147 10 CANL 5.806,0.499 5.978,0.645 0.172,0.147 10 21 5.806,2.269 5.978,2.415 0.172,0.147 10 25 5.806,2.773 5.978,2.920 0.172,0.147 10 26 4.133,1.68 4.306,1.826 0.172,0.147 10 20 0.556,1.256 1.520,1.393 0.964,0.137 10 from IG2 Relay 3.305,0.576 4.261,0.713 0.957,0.137 10 from IG2 Relay 3.148,1.826 3.370,1.968 0.222,0.142 10 B 3.157,1.261 3.448,1.403 0.291,0.142 10 IG+ 0.773,4.184 2.555,4.330 1.782,0.147 10 : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK AUXILIARY BATTERY VOLTAGE
a.

Measure the voltage of the auxiliary battery.

Standard Voltage:

11 to 14 V




OK

2.CHECK CONNECTOR

NG

2.CHECK CONNECTOR
a.

Turn the power switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.

Check that the connector is properly connected to the combination meter sub-assembly.

OK:

The connector is properly connected.


HINT:

If the connector is not connected securely, reconnect the connector and proceed to the next inspection.



d.

Disconnect the connector from the combination meter sub-assembly.


e.

Check that the terminal of the connector is not damaged.

OK:

The terminal is not deformed or damaged.




OK

3.CHECK WIRE HARNESS (COMBINATION METER SUB-ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE CONNECTOR

3.CHECK WIRE HARNESS (COMBINATION METER SUB-ASSEMBLY - BODY GROUND)
a.
U154948E01
0.081,0.069 0.244,0.238 0.164,0.169 10 *a 0.231,0.993 0.480,1.149 0.249,0.156 10 IG+ 2.764,0.763 2.976,0.919 0.212,0.156 10 ES 0.402,1.705 0.513,1.861 0.111,0.156 10 B 0.874,1.597 0.54,1.79 false 0.992,1.513 0.558,1.081 false 2.074,1.504 2.726,0.852 false 0.189,0.409 0.461,0.590 0.272,0.181 10 L27

Connect the cable to the negative (-) auxiliary battery terminal.


b.

Turn the power switch on (IG).


c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L27-2 (IG+) - Body ground Power switch on (IG) 11 to 14 V
L27-1 (B) - Body ground Power switch off 11 to 14 V



d.

Turn the power switch off.


e.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L27-11 (ES) - Body ground Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Combination Meter Sub-assembly)



OK

4.CHECK SRS WARNING LIGHT

NG

REPAIR OR REPLACE WIRE HARNESS

4.CHECK SRS WARNING LIGHT
a.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



b.

Connect the connector to the combination meter sub-assembly.


c.

Disconnect the connector from the airbag ECU assembly.


d.

Connect the cable to the negative (-) auxiliary battery terminal.


e.

Turn the power switch on (IG).


f.

Check the SRS warning light condition.

OK:

After the primary check period, the SRS warning light goes off for approximately 10 seconds and turns back on.


HINT:

The primary check period is approximately 6 seconds after the power switch is turned on (IG).




OK

NG