Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2014.11
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301798 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

Deceleration sensors used for the airbag system are installed to various parts on the vehicle and calculate the deceleration rate of each part during a collision.


b.

Depending on the situation, the airbag ECU assembly sends a deployment signal to each airbag and pretensioner based on the information from each sensor.



DEPLOYMENT CONDITION


a.

FRONTAL COLLISION

C238252E09
0.354,2.167 1.76,2.354 1.406,0.188 10 false Airbag ECU Assembly 0.396,3.49 1.792,3.698 1.396,0.208 10 false Front Airbag Sensors 2.594,2.854 2.938,3.063 0.344,0.208 10 false AND 4.073,0.573 6.698,0.771 2.625,0.198 10 false Horn Button Assembly (Driver Side Squib) 3.927,1.281 6.802,1.635 2.875,0.354 10 false Instrument Panel Passenger Airbag Assembly (Front Passenger Side Squib) 3.906,2.188 6.865,2.531 2.958,0.344 10 false Lower No. 1 Instrument Panel Airbag Assembly (Driver Side Knee Airbag Squib) 4.167,3.083 6.344,3.521 2.177,0.438 10 false Front Seat Airbag Assembly LH/RH (Front Side Squib LH/RH) 4.177,3.958 6.604,4.323 2.427,0.365 10 false Curtain Shield Airbag Assembly LH/RH (Curtain Shield Squib LH/RH) 4.198,4.885 6.646,5.24 2.448,0.354 10 false Front Seat Outer Belt Assembly LH/RH (Front Pretensioner Squib LH/RH)

i.

Frontal collision signals are produced based on the information from the airbag ECU assembly and front airbag sensors.

HINT:

In the case of a frontal collision, the SRS ignition signal may be output after receiving an ON signal from the deceleration sensor built into the airbag ECU assembly even without a signal from the front airbag sensors.



ii.

Frontal collision signals are used to deploy the SRS parts in the diagram.



b.

SIDE COLLISION (Pattern 1)

C261681E06
4.875,0.271 6.646,0.604 1.771,0.333 10 false Front Seat Airbag Assembly (Front Side Squib) 4.76,1.135 6.719,1.5 1.958,0.365 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.49,0.76 1.719,1.104 1.229,0.344 10 false Side Airbag Sensor Assembly 0.417,1.698 1.813,1.906 1.396,0.208 10 false Airbag ECU Assembly 3.448,1.333 3.76,1.521 0.313,0.188 10 false AND 4.771,1.979 6.781,2.344 2.01,0.365 10 false Front Seat Outer Belt Assembly (Front Pretensioner Squib)

i.

Side collision (Pattern 1) signals are produced based on the information from the airbag ECU assembly and side airbag sensor assembly.


ii.

Side collision (Pattern 1) signals are used to deploy the SRS parts in the diagram.



c.

SIDE COLLISION (Pattern 2)

C240621E10
4.875,1.094 6.875,1.427 2,0.333 10 false Curtain Shield Airbag Assembly (Curtain Shield Squib) 0.135,0.479 2.385,0.677 2.25,0.198 10 false Side No. 2 Airbag Sensor Assembly 0.563,2.021 1.969,2.229 1.406,0.208 10 false Airbag ECU Assembly 3.479,1.302 3.792,1.49 0.313,0.188 10 false AND

i.

Side collision (Pattern 2) signals are produced based on the information from the airbag ECU assembly and side No. 2 airbag sensor assembly.


ii.

Side collision (Pattern 2) signals are used to deploy the SRS part in the diagram.