82143C
1.INSTALL NO. 3 INSTRUMENT PANEL WIRE
Connect the airbag connector to the instrument panel passenger airbag assembly.
| *1 | Airbag Connector |
| *2 | Airbag Connector Lock |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the airbag connector lock to install the airbag connector to the instrument panel passenger airbag assembly.
Engage the clamp and connect the No. 3 instrument panel wire to the instrument panel passenger airbag assembly clamp.
73960A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Engage the 3 hooks.
Push the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the 2 screws to install the instrument panel passenger airbag assembly.
3.INSTALL UPPER INSTRUMENT PANEL ASSEMBLY
82143C
4.CONNECT NO. 3 INSTRUMENT PANEL WIRE
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
55414A
5.INSTALL INSTRUMENT CLUSTER FINISH PANEL END (w/ Headup Display)
6. PERFORM DIAGNOSTIC SYSTEM CHECK