Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301802 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 55414A 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (w/ Headup Display)

Hide 82143C 3.DISCONNECT NO. 3 INSTRUMENT PANEL WIRE

a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
U190895E02
1.781,0.552 1.781,1.021 false 2.188,0.948 2.375,1.135 0.188,0.188 10 false *a

Slide the slider to release the lock, and then disconnect the connector.

Text in Illustration
*a Slider

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B274051

Remove the 2 screws.


b.
B274052

Using a screwdriver, lean the instrument panel safety pad and disengage the 3 hooks as shown in the illustration.

NOTICE:

Do not damage the deployment surface of the instrument panel passenger airbag assembly.



c.
B274053

Disengage the 3 hooks to remove the instrument panel passenger airbag assembly from the upper instrument panel assembly as shown in the illustration.


Hide 82143C 6.REMOVE NO. 3 INSTRUMENT PANEL WIRE

a.
B274055E01
1.427,2.701 1.578,2.860 0.151,0.159 10 *1 1.498,2.01 1.498,2.701 false 0.924,0.161 1.074,0.321 0.151,0.159 10 *3 0.748,0.597 0.748,0.249 0.748,0.249 0.902,0.249 false 1.202,2.109 0.597,2.109 false 0.417,2.028 0.568,2.187 0.151,0.159 10 *2

Disengage the clamp and disconnect the No. 3 instrument panel wire from the instrument panel passenger airbag assembly clamp.


b.

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock.

Text in Illustration
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock


c.

Disconnect the airbag connector to remove the No. 3 instrument panel wire from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.