Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY › from 2016.05
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301803 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT ROOF HEADLINING ASSEMBLY

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

CAUTION:

When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


NOTICE:

Do not damage the roof headlining assembly.


a.

Check that the power switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B282160E03
1.281,2.167 0.948,1.833 0.948,1.833 0.781,1.833 false 1.438,2.083 1.865,2.083 true 2.604,0.802 2.271,1.135 2.271,1.135 2.146,1.135 true 0.604,1.771 0.771,1.938 0.167,0.167 10 false *1 1.906,1.99 2.115,2.188 0.208,0.198 10 true *2 1.948,1.063 2.115,1.229 0.167,0.167 10 false *3

Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

Text in Illustration
*1 Protective Tape
*2 Airbag Connector
*3 Airbag Connector Lock

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



d.

Remove the 10 bolts.

B312051


e.

Disengage the 10 hooks to remove the curtain shield airbag assembly.

B312052

NOTICE:

When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.