Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301805 CENTER AIRBAG SENSOR ASSEMBLY G

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the airbag ECU assembly.


PROCEDURE

Hide 89170A 1.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle not Involved in Collision)

Hide 89170A 2.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)


b.

Visually check for defects with the airbag ECU assembly installed on the vehicle.

HINT:

The defects are as follows:

·

Cracks on the ECU housing

·

Dents on the ECU housing

·

Chips on the ECU housing

·

Cracks or other damage to the connector

·

Peeling of the label



OK:

No defects are found.


If any of the defects is found, replace the airbag ECU assembly with a new one.


Hide 89170A 3.INSPECT AIRBAG ECU ASSEMBLY (for Vehicle Involved in Collision and Airbag is Deployed)

a.

Replace the airbag ECU assembly.

HINT:

The airbag ECU assembly should be replaced after any of the airbags has deployed, as it has been subjected to an impact.