Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG CUT-OFF SWITCH › from 2016.05
RM2070E _58 Vehicle Interior _061942 SUPPLEMENTAL RESTRAINT SYSTEMS _0301809 AIRBAG CUT-OFF SWITCH G

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG CUT-OFF SWITCH  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


PROCEDURE

Hide 69065A 1.INSPECT AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY

a.

Turn the power switch off.


b.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
U191145E01
0.225,0.162 0.422,0.385 0.198,0.223 10 *a 2.75,0.743 3.162,0.899 0.412,0.157 10 PMC+ 2.75,1.198 3.137,1.355 0.387,0.157 10 PMC- 2.331,1.039 2.737,0.834 false 2.332,1.125 2.739,1.282 false 2.773,0.421 3.123,0.584 0.350,0.163 10 L148

Disconnect the connector from the airbag cut off switch cylinder sub-assembly.


d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
L148-2 (PMC+) - L148-1 (PMC-) Cut off switch in ON 360 to 440 Ω
L148-2 (PMC+) - L148-1 (PMC-) Cut off switch in OFF 90 to 110 Ω


Text in Illustration
*a Component without harness connected
(Airbag Cut Off Switch Cylinder Sub-assembly)

If the result is not as specified, replace the airbag cut off switch cylinder sub-assembly.