Use the same procedure for the front passenger side of RHD and LHD vehicles.
The procedures listed below are for the front passenger side of an LHD vehicle.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67911B
8.REMOVE FRONT DOOR SCUFF PLATE RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
62111C
9.REMOVE COWL SIDE TRIM BOARD RH
Use the same procedure for the RH side and LH side (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).
62311B
10.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the front door opening trim weatherstrip RH to the extent that allows the removal of the instrument panel finish panel end RH.
55440D
11.REMOVE INSTRUMENT PANEL BOX ASSEMBLY
12.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
55435A
13.REMOVE INSTRUMENT PANEL FINISH PANEL END RH
69065A
14.REMOVE AIRBAG CUT OFF SWITCH CYLINDER SUB-ASSEMBLY
Disengage the 2 claws to remove the airbag cut off switch cylinder sub-assembly.