Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR


a.

If the pre-crash system is not functioning properly, the driver is warned by the PCS warning indicator on the combination meter.

PCS Warning Indicator Detail DTC
Blinking This PCS warning indicator appears when the seat belt control ECU or driving support ECU assembly detect a system malfunction ○
On This PCS warning indicator appears when the seat belt control ECU or driving support ECU assembly is in fail-safe mode (See page (Click here)) -


b.

Initial check

i.

The initial check occurs when the power switch is off for more than 2 seconds, and then turned on (IG). The initial check consists of a pre-crash system diagnostic check with a duration of approximately 3 seconds.


ii.

If a malfunction is detected during the initial check, PCS warning indicator illuminates in the combination meter assembly.



c.

Constant check

i.

The seat belt control ECU and driving support ECU assembly constantly monitor the pre-crash system for malfunctions after the power switch is turned on (IG) and initial check (approximately 3 seconds) is completed.


ii.

The PCS warning indicator blinks, when the constant check detects malfunctions in the pre-crash system.