Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.11–2017.12
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  



FUNCTION OF WARNING INDICATOR


a.

If the pre-crash system is not functioning properly, the driver is warned by the PCS warning light and a warning message on the multi-information display in the combination meter sub-assembly.

Warning Message Detail DTC PCS Warning Light
PRE-CRASH SAFETY MALFUNCTION VISIT YOUR DEALER This message is displayed when the driving support ECU assembly detects a system malfunction ○ Flashes
PRE-CRASH SAFETY UNAVAILABLE This message is displayed when the driving support ECU assembly is in fail-safe mode (See page (Click here)) - Flashes


b.

Initial check

i.

The initial check occurs when the power switch is off for more than 2 seconds, and then turned on (IG). The initial check consists of a pre-crash system diagnostic check with a duration of approximately 3 seconds.


ii.

If a malfunction is detected during the initial check, the multi-information display will display "PRE-CRASH SAFETY MALFUNCTION VISIT YOUR DEALER" or "PRE-CRASH SAFETY UNAVAILABLE".



c.

Constant check

i.

The driving support ECU assembly constantly monitors the pre-crash system for malfunctions after the power switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.


ii.

"PRE-CRASH SAFETY MALFUNCTION VISIT YOUR DEALER" or "PRE-CRASH SAFETY UNAVAILABLE" is displayed on the multi-information display in the combination meter sub-assembly when the constant check detects malfunctions in the pre-crash system.