The driving support ECU assembly uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.
Based on this information, the driving support ECU assembly calculates the risk of a crash and operates the pre-crash system when it determines that the risk is high.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1A01 | When the power switch is on (IG), the driving support ECU assembly detects an internal malfunction for 1.5 seconds or more. | Driving support ECU assembly |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
Body Electrical / Pre-Crash 2 / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
DTC C1A01 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG