Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A02  Vehicle Information Not Obtained  


DESCRIPTION

When a new driving support ECU assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD information, etc.) from the main body ECU and power management control ECU and memorizes the information.

DTC C1A02 is stored when the driving support ECU assembly receives the vehicle specification information from the main body ECU but cannot record it.

DTC No. DTC Detection Condition Trouble Area
C1A02 Inconsistent vehicle specification information between the main body ECU and driving support ECU assembly continues for 13 second or more while the vehicle is being driven at a speed of 50 km/h (31 mph) or more.
·

CAN communication system

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.




f.

Recheck for DTCs.

OK:

CAN communication system DTC is not output.




OK

REPLACE DRIVING SUPPORT ECU ASSEMBLY

NG