84770A
1.INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY (w/o Automatic High Beam System)
Check the pre-crash system cancel switch assembly.
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Pre-crash System Cancel Switch Assembly) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 - 8 | Not pushed | 10 kΩ or higher |
| 5 - 8 | Pushed | Below 1 Ω |
Check the switch illumination and indicator.
Apply auxiliary battery voltage to the pre-crash system cancel switch assembly and check that the switch illumination and each indicator come on.
| Auxiliary battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → 3
Auxiliary battery positive (-) → 2 |
Switch illumination comes on |
84010D
2.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY) (w/ Automatic High Beam System)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 8 | Pressed | Below 1 Ω |
| Not pressed | 10 kΩ or higher |
| *a | Component without harness connected
(Integration Control and Panel Assembly (Pre-crash System Cancel Switch Assembly)) |
Check the switch illumination and indicator.
Apply auxiliary battery voltage to the integration control and panel assembly (pre-crash system cancel switch assembly) and check that the switch illumination and each indicator come on.
| Auxiliary battery Connection | Specified Condition |
|---|---|
| Auxiliary battery positive (+) → 4
Auxiliary battery positive (-) → 1 |
Switch illumination comes on |