Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061944 SEAT _0301814 FRONT POWER SEAT CONTROL SYSTEM D

SEAT  FRONT POWER SEAT CONTROL SYSTEM  OPERATION CHECK  


CHECK POWER SEAT FUNCTION


a.
B289319E01
1.661,1.818 1.217,1.205 1.217,1.205 0.793,1.205 false 0.584,1.124 0.739,1.273 0.156,0.149 10 *1

Check the basic function.

Text in Illustration
*1 Lumber Support Adjustment Function

i.

Operate the lumbar support switch and check to make sure the seat function works:

·

Lumbar support adjustment function





CHECK LUMBAR SUPPORT MOTOR


a.

Inspect the PTC operation inside the power seat motor.

NOTICE:

The inspection should be performed with the seat installed in the vehicle.


i.

Move the lumbar support to either the foremost or rearmost position by operating the power seat switch assembly, and keep it there for approximately 60 seconds.


ii.

Try to move the lumbar support beyond the maximum position using the switch. Measure the time needed for shutting off the electrical current after the lumbar support stops moving (verify when current is shut off or listening for the motor to stop).

Standard:

4 to 90 seconds



iii.

Release the power seat switch assembly and wait for approximately 60 seconds.


iv.

Operate the power seat switch assembly to move the lumbar support to the opposite position and check that the motor operates.