1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
71910A
8.REMOVE FRONT SEAT HEADREST ASSEMBLY
72128A
9.REMOVE FRONT INNER SEAT TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Disengage the 2 claws and remove the front inner seat track bracket cover.
72124
10.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER
Disengage the 2 claws and remove the front outer seat track bracket cover.
72138H
11.REMOVE REAR INNER SEAT TRACK BRACKET COVER
Lift up the seat track adjusting handle and move the seat to the foremost position.
Disengage the claw.
Disengage the guide and remove the rear inner seat track bracket cover.
72138J
12.REMOVE REAR OUTER SEAT TRACK BRACKET COVER
Disengage the 2 claws and remove the rear outer seat track bracket cover.
13.REMOVE FRONT SEAT ASSEMBLY
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Operate the vertical adjusting handle to move the seat cushion to the upper position.
Disconnect each connector and clamp under the seat.
Remove the front seat assembly.
Be careful not to damage the vehicle body.