84751
1.INSPECT SEAT HEATER SWITCH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (IG) - 3 (LH) | "L" switch off | 10 kΩ or higher |
| 4 (IG) - 3 (LH) | "L" switch on | Below 1 Ω |
| 5 (IG) - 6 (RH) | "R" switch off | 10 kΩ or higher |
| 5 (IG) - 6 (RH) | "R" switch on | Below 1 Ω |
| *a | Component without harness connected
(Seat Heater Switch) |
If the result is not as specified, replace the seat heater switch.
Turn the seat heater switch on and check if the seat heater switch indicator comes on.
| Connection | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 4 (IG)
Auxiliary battery negative (-) → 2 (E) |
"L" Switch on | Comes on |
| Auxiliary battery positive (+) → 5 (IG)
Auxiliary battery negative (-) → 2 (E) |
"R " Switch on | Comes on |
If the result is not as specified, replace the seat heater switch.
Check if the seat heater switch comes on.
| Connection | Condition | Specified Condition |
|---|---|---|
| Auxiliary battery positive (+) → 7 (ILL+)
Auxiliary battery negative (-) → 8 (ILL-) |
Always | Comes on |
If the result is not as specified, replace the seat heater switch.