Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › from 2016.05
RM2070E _58 Vehicle Interior _061944 SEAT _0301824 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:
·

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).

·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

If the front seat side airbag assembly has deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.



NOTICE:
·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 71910A 7.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 72128A 8.REMOVE FRONT INNER SEAT TRACK BRACKET COVER

a.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.


b.
B392085

Disengage the 2 claws to remove the front inner seat track bracket cover.


Hide 72124 9.REMOVE FRONT OUTER SEAT TRACK BRACKET COVER

a.
B392086

Disengage the 2 claws to remove the front outer seat track bracket cover.


Hide 72138H 10.REMOVE REAR INNER SEAT TRACK BRACKET COVER

a.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the foremost position.


b.
B292167

Disengage the claw.


c.

Disengage the guide to remove the rear inner seat track bracket cover.


Hide 72138J 11.REMOVE REAR OUTER SEAT TRACK BRACKET COVER

a.
B292166

Disengage the 2 claws to remove the rear outer seat track bracket cover.


Hide 12.REMOVE FRONT SEAT ASSEMBLY

a.
B392068

Remove the 2 bolts on the rear side of the front seat assembly.


b.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the rearmost position.


c.
B392069

Remove the 2 bolts on the front side of the front seat assembly.


d.

Operate the reclining power seat switch knob and move the seatback to the upright position.


e.

Operate the slide and vertical power seat switch knob and move the front seat assembly to the center position.


f.

Disconnect the cable from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative auxiliary (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



g.

Disconnect each connector under the front seat assembly.


h.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.