73240
1.REMOVE FRONT SEAT INNER BELT ASSEMBLY
71868A
2.REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD
Disengage the clamp. c.
Remove the screw.
Disengage the front inner No. 1 seat cushion shield from the clip as shown in the illustration.
Disengage the 3 claws and 3 guides to remove the front inner No. 1 seat cushion shield.
Remove the clip.
71849
3.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 seat adjuster cover caps.
4.REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY
Disconnect the 4 connectors.
Disengage the 6 clamps to disconnect the No. 1 front seat wire.
Disengage the clip.
Disengage the guide as shown in the illustration.
Disengage the 5 claws to separate the front seat cushion shield assembly.
Disconnect the 2 connectors.
Disengage the clamp to remove the front seat cushion shield assembly.
84921B
5.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a moulding remover, disengage the 4 claws to remove the slide and vertical power seat switch knob.
84921A
6.REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a moulding remover, disengage the 4 claws to remove the reclining power seat switch knob.
84922C
7.REMOVE FRONT POWER SEAT SWITCH
84920
8.REMOVE LUMBAR SWITCH (POWER SEAT SWITCH ASSEMBLY)
82192
9.REMOVE NO. 1 FRONT SEAT WIRE
Disengage the 2 claws and 2 clamps to remove the No. 1 front seat wire from the front seat cushion shield.
71862
10.REMOVE FRONT INNER SEAT CUSHION SHIELD
Disengage the 5 claws to remove the front inner seat cushion shield.
11.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Disconnect the rubber band.
Disengage the 4 hooks.
w/ Seat Heater System:
Disengage the 3 clamps.
w/ Seat Heater System:
Disconnect the connector.
w/ Seat Heater System:
Disengage the clamp to separate the seat heater wire harness.
Disengage the fastener to separate the side airbag wire harness.
Disengage the 2 hooks as shown in the illustration.
Disengage each hook as shown in the illustration and remove the separate type front seat cushion cover with pad from the separate type front seat cushion spring assembly.
71072S
12.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 2 hog rings
Remove the 11 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
13.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Remove the 2 hog rings.
Remove the 3 hog rings.
Remove the 3 hog rings to disconnect the 2 fastening rubbers.
| *a | Fastening Rubber |
Turn back the separate type front seatback cover, remove the nut, and separate the bracket of the separate type front seatback cover.
Disengage the 4 claws and remove the 2 front seat headrest supports.
Remove the separate type front seatback cover with pad from the separate type front seatback spring assembly.
71074S
14.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 5 hog rings.
Remove the 2 hog rings to disconnect the fastening rubber.
| *a | Fastening Rubber |
Remove the separate type front seatback cover from the separate type front seatback pad.
82168
15.REMOVE NO. 2 FRONT SEAT WIRE
Disconnect the 2 connectors.
Disengage the 3 clamps to remove the No. 2 front seat wire from the separate type front seatback spring assembly.
71875G
16.REMOVE RECLINING ADJUSTER INSIDE COVER LH
Disengage the 2 guides to remove the reclining adjuster inside cover LH from the separate type front seatback spring assembly.
71876
17.REMOVE RECLINING ADJUSTER INSIDE COVER RH
Use the same procedure as for the LH side.
71874A
18.REMOVE FRONT SEAT LOWER CUSHION SHIELD LH
Disengage the hook as shown in the illustration.
Remove the screw.
Disengage the clip to remove the front seat lower cushion shield LH from the separate type front seat cushion spring assembly.
71873A
19.REMOVE FRONT SEAT LOWER CUSHION SHIELD RH
Use the same procedure as for the LH side.
71537F
20.REMOVE NO. 2 FRONT SEAT CUSHION PROTECTOR
Remove the screw.
Disengage the 2 guides to remove the No. 2 front seat cushion protector from the separate type front seatback spring assembly.
71537E
21.REMOVE NO. 1 FRONT SEAT CUSHION PROTECTOR
Use the same procedure as for the No. 2 front seat cushion protector.
22.REMOVE SEPARATE TYPE FRONT SEATBACK SPRING ASSEMBLY
Remove the 4 bolts.
Disengage the 4 guides to remove the separate type front seatback spring assembly from the separate type front seat cushion spring assembly.
73920A
23.REMOVE FRONT SEAT AIRBAG ASSEMBLY