Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2070E _58 Vehicle Interior _061945 SEAT BELT _0301827 FRONT SEAT OUTER BELT ASSEMBLY G

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSPECTION  


PROCEDURE

Hide 73210 1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B276799E01
0.255,0.202 0.404,0.342 0.149,0.140 10 *a 0.556,2.213 0.705,2.353 0.149,0.140 10 *1

Check the pre-crash seat belt. (w/ Pre-crash Safety System)

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance
Tester Connection Condition Specified Condition
1 - 2 Always Below 1 MΩ

Text in Illustration
*1 Pre-crash Seat Belt Connector
*a Component without harness connected
(Front Seat Outer Belt Assembly)

If the result is not as specified, replace the front seat outer belt assembly.




b.
B131510E14
2.405,0.063 2.56,0.26 0.155,0.198 10 *a 2.161,1.708 2.327,1.859 0.166,0.152 10 *1 0.22,1.094 0.379,1.241 0.159,0.147 10 *b 0.879,0.207 1.045,0.356 0.167,0.15 10 *c 1.454,1.686 2.123,1.686 2.123,1.686 2.037,1.346 false

Before installing the outer belt, check the ELR function.

NOTICE:

Do not disassemble the retractor.


i.

When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

Text in Illustration
*1 Retractor
*a Unlocked
*b Locked
*c 45°

If the result is not as specified, replace the front seat outer belt assembly.