Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY › 2013.08–2014.11
RM2070E _58 Vehicle Interior _061945 SEAT BELT _0301827 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 62312B 9.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the front door opening trim weatherstrip.


Hide 62332A 11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

a.

Disconnect the rear door opening trim weatherstrip.


Hide 73233 12.REMOVE LAP BELT OUTER ANCHOR COVER

a.
B283090

Disengage the 3 claws and remove the lap belt outer anchor cover.


Hide 73220 13.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B283091

Remove the bolt and disconnect the floor end of the front seat outer belt assembly.


Hide 62414A 14.REMOVE CENTER PILLAR LOWER GARNISH

Hide 73220 16.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B283092

Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.


b.
B283093E03
0.844,1.177 1.031,1.344 0.188,0.167 10 true *A 0.75,1.604 0.917,1.76 0.167,0.156 10 true *1

Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

Text in Illustration
*A w/ Pre-crash Safety System
*1 Pretensioner Connector

HINT:

Tape the screwdriver tip before use.



c.

Disconnect the connector.


d.

w/ Pre-crash Safety System:

i.

Disconnect the connector.



e.
B283094

Remove the 2 bolts and front seat outer belt assembly.


Hide 73200A 17.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B283095

Remove the 2 bolts.


b.

Disengage the guide and remove the front shoulder belt anchor adjuster assembly.