Use the same procedure for the RH side and LH side.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67914
8.REMOVE FRONT DOOR SCUFF PLATE
62312B
9.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
Disconnect the front door opening trim weatherstrip.
67918A
10.REMOVE REAR DOOR SCUFF PLATE
62332A
11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
73233
12.REMOVE LAP BELT OUTER ANCHOR COVER
Disengage the 3 claws and remove the lap belt outer anchor cover.
73220
13.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
Remove the bolt and disconnect the floor end of the front seat outer belt assembly.
62414A
14.REMOVE CENTER PILLAR LOWER GARNISH
62412
15.REMOVE CENTER PILLAR GARNISH
73220
16.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.
Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
| *A | w/ Pre-crash Safety System |
| *1 | Pretensioner Connector |
Tape the screwdriver tip before use.
Disconnect the connector.
w/ Pre-crash Safety System:
Disconnect the connector.
Remove the 2 bolts and front seat outer belt assembly.
73200A
17.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Remove the 2 bolts.
Disengage the guide and remove the front shoulder belt anchor adjuster assembly.