Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM
RM2070E _58 Vehicle Interior _061945 SEAT BELT _0301836 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter or Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
P-Seatbelt Buckle SW Front passenger seat belt buckle switch signal/ON or OFF ON: Front passenger seat belt not fastened
OFF: Front passenger seat belt fastened
-
2nd-Row Seatbelt Buckle (R) Rear No. 1 seat belt RH buckle switch signal/ON or OFF ON: Rear No. 1 seat belt RH not fastened
OFF: Rear No. 1 seat belt RH fastened
-
2nd-Row Seatbelt Buckle (L) Rear No. 1 seat belt LH buckle switch signal/ON or OFF ON: Rear No. 1 seat belt LH not fastened
OFF: Rear No. 1 seat belt LH fastened
-
2nd-Row Seatbelt Buckle (C) Rear No. 1 seat belt center buckle switch signal/ON or OFF ON: Rear No. 1 seat belt center not fastened
OFF: Rear No. 1 seat belt center fastened
-
3rd-Row Seatbelt Buckle (R) Rear No. 2 seat belt RH buckle switch signal/ON or OFF ON: Rear No. 2 seat belt RH not fastened
OFF: Rear No. 2 seat belt RH fastened
-
3rd-Row Seatbelt Buckle (L) Rear No. 2 seat belt LH buckle switch signal/ON or OFF ON: Rear No. 2 seat belt LH not fastened
OFF: Rear No. 2 seat belt LH fastened
-
Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer/ON or OFF Customized value displayed -
P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer/ON or OFF Customized value displayed -
Rear Seatbelt Warning Buzzer Rear seat belt warning buzzer/OFF or ON Customized value displayed -

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RR Door Courtesy SW Rear door courtesy light switch RH/ ON or OFF ON: Rear door RH or LH open
OFF: Rear door RH and LH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH/ ON or OFF ON: Rear door LH or RH open
OFF: Rear door LH and RH closed
-
D Seat Buckle SW Driver seat belt buckle switch/ON or OFF ON: Driver seat belt fastened
OFF: Driver seat belt unfastened
-



ACTIVE TEST


Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Driver Side Seat Belt Seat belt warning light OFF/ON -
Rear Seat Belt Rear seat belt warning light OFF/ON -