Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301837 AIR CONDITIONING SYSTEM U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  TERMINALS OF ECU  


AIR CONDITIONING AMPLIFIER ASSEMBLY


U155009E03
6.167,0.198 6.438,0.385 0.271,0.188 10 false z11 4.052,0.198 4.323,0.354 0.271,0.156 10 false L17

HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
L17-1 (IG+) - L17-14 (GND) P - W-B Power source (IG) Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
L17-5 (TAM) - L17-13 (SG-2) R - G Ambient temperature sensor signal Power switch on (IG)
Ambient temperature: 25°C (77°F)
1.35 to 1.75 V
Power switch on (IG)
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
L17-9 (PRE) - L17-13 (SG-2) L - G Air conditioning pressure sensor signal A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3.025 MPa (30.8 kgf/cm2, 439 psi))
4.69 V or higher
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 0.167 MPa (1.7 kgf/cm2, 24 psi))
Below 0.70 V
A/C system operating
Refrigerant pressure: Normal pressure (less than 3.025 MPa (30.8 kgf/cm2, 439 psi) and more than 0.167 MPa (1.7 kgf/cm2, 24 psi))
0.70 to 4.69 V
L17-10 (S5-3) - L17-13 (SG-2) LG - G Power supply for air conditioning pressure sensor Power switch on (IG) 4.75 to 5.25 V
Power switch off Below 1 V
L17-11 (CANH) - L17-12 (CANL) B - W CAN communication system CAN communication circuit Pulse generation
L17-13 (SG-2) - Body ground G - Body ground Ground for air conditioning pressure sensor, ambient temperature sensor Always Below 1 V
L17-14 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 V
L17-15 (ECOS) - L17-14 (GND) V - W-B Combination switch (ECO switch) signal Power switch on (IG)
Combination switch (ECO switch) off
11 to 14 V
Power switch on (IG)
Combination switch (ECO switch) on
Below 1 V
L17-16 (PTC3) - L17-14 (GND)*1 BR - W-B PTC heater operation signal Power switch on (READY)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 65°C (149°F) or lower
Light control switch off
Blower switch on
11 to 14 V
L17-18 (PTC1) - L17-14 (GND)*1 W - W-B PTC heater operation signal Power switch on (READY)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 75°C (167°F) or lower
Light control switch off
Blower switch on
11 to 14 V
L17-20 (RDFG) - L17-14 (GND) SB - W-B Rear defogger switch signal Power switch on (IG)
Rear defogger switch off
11 to 14 V
Power switch on (IG)
Rear defogger switch on
Below 1 V
L17-21 (B) - L17-14 (GND) Y - W-B Power source (Back-up) Power switch off 11 to 14 V
L17-23 (BLW) - L17-14 (GND) L - W-B Blower motor speed control signal Power switch on (IG)
Blower switch: LO
Pulse generation
(See waveform 1)
L17-27 (IDH) - L17-14 (GND)*1 P - W-B Inverter with converter assembly current over signal Power switch on (IG)
Quick heater assembly operation permitted
Less than 1 V
Power switch on (IG)
Quick heater assembly operation not permitted
4.75 to 5.25 V
L17-29 (TR) - L17-34 (SG-1) Y - L Room temperature sensor signal Power switch on (IG)
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
Power switch on (IG)
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
L17-33 (TS) - L17-14 (GND) GR - W-B Solar sensor signal Power switch on (IG)
Solar sensor subjected to electric light
0.8 to 4.3 V
Power switch on (IG)
Solar sensor covered with a cloth
Below 0.8 V
L17-34 (SG-1) - Body ground L - Body ground Ground for room temperature sensor Always Below 1 V
L17-37 (LIN1) - L17-14 (GND) V - W-B LIN communication signal Power switch on (IG) Pulse generation
L17-38 (PTC2) - L17-14 (GND)*1 B - W-B PTC heater operation signal Power switch on (READY)
Temperature setting: MAX. HOT
Ambient temperature: 10°C (50°F) or lower
Engine coolant temperature: 65°C (149°F) to 70°C (158°F)
Light control switch off
Blower switch on
11 to 14 V
z11-2 (BUS G) - Body ground - Ground for BUS IC Always Below 1 V
z11-3 (BUS) - z11-2 (BUS G) - BUS IC control signal Power switch on (IG) Pulse generation
z11-4 (B BUS) - z11-2 (BUS G) - Power supply for BUS IC Power switch off 11 to 14 V
z11-5 (SGA) - Body ground - Ground for evaporator temperature sensor Always Below 1 V
z11-6 (TEA) - z11-5 (SGA) - Evaporator temperature sensor signal Power switch on (IG)
Evaporator temperature: 0°C (32°F)
2.0 to 2.4 V
Power switch on (IG)
Evaporator temperature: 15°C (59°F)
1.4 to 1.8 V

*1: w/ Quick Heater Assembly


a.
E103396E67
2.917,1.656 3.313,1.865 0.396,0.208 10 false GND

Waveform 1:

Item Content
Terminal No. L17-23 (BLW) - L17-14 (GND)
Tool Setting 1 V/DIV., 500 μs/DIV.
Vehicle Condition Power switch on (IG)
Blower switch: LO



CENTER CLUSTER MODULE CIRCUIT (AIR CONDITIONING CONTROL ASSEMBLY)


U155096E03
3.469,0.25 3.74,0.427 0.271,0.177 10 false L20

HINT:

Check from the rear of the connector while it is connected to the center cluster module circuit (air conditioning control assembly).


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
L20-1 (GND) - Body ground W-B - Body ground Ground for center cluster module circuit (air conditioning assembly) Always Below 1 V
L20-3 (TX+) - Body ground V - Body ground LIN communication signal Power switch on (IG) Pulse generation
L20-7 (ILL+) - L20-12 (ILL-) P - W-B Light control switch signal Light control switch tail or head position 11 to 14 V
Light control switch off Below 1 V
L20-10 (SWO) - Body ground L - Body ground Steering pad switch assembly signal No switch pushed
→ R/F switch pushed
→ TEMP+ switch pushed
→ TEMP- switch pushed
4.44 to 5.43 V
→ 1.19 to 1.49 V
→ 2.09 to 2.54 V
→ 3.2 to 3.88 V
L20-16 (IG+) - Body ground Y - Body ground Power source (IG) Power switch on (IG) 11 to 14 V
Power switch off Below 1 V