Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301837 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1413/13  Evaporator Temperature Sensor Circuit  


DESCRIPTION

The evaporator temperature sensor (No. 1 cooler thermistor) is installed on the evaporator in the air conditioning unit to detect the cooled air temperature that has passed through the evaporator and to control the air conditioning. It sends appropriate signals to the air conditioning amplifier assembly. The resistance of the evaporator temperature sensor (No. 1 cooler thermistor) changes in accordance with the cooled air temperature that has passed through the evaporator. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the evaporator temperature sensor (No. 1 cooler thermistor) and reads voltage changes as the resistance of the evaporator temperature sensor (No. 1 cooler thermistor) changes. This sensor is used for frost prevention.

DTC No. DTC Detection Condition Trouble Area
B1413/13 Open or short in evaporator temperature sensor (No. 1 cooler thermistor) circuit
·

Evaporator temperature sensor (No. 1 cooler thermistor)

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly



WIRING DIAGRAM

E229251E62
2.063,1.396 2.365,1.625 0.302,0.229 10 false 2 2.031,0.448 2.469,0.677 0.438,0.229 10 false 1 4.76,0.448 5.052,0.708 0.292,0.26 10 false 6 4.75,1.396 4.99,1.615 0.24,0.219 10 false 5 5,0.563 5.531,0.844 0.531,0.281 10 false TEA 2.74,1.938 4.271,2.333 1.531,0.396 10 false Air Conditioning Harness Assembly 4.99,1.49 5.469,1.698 0.479,0.208 10 false SGA 0.469,1.823 0.76,2.031 0.292,0.208 10 false ad 0.469,1.99 2.396,2.469 1.927,0.479 10 false Evaporator Temperature Sensor (No. 1 Cooler Thermistor) 4.729,1.927 5,2.104 0.271,0.177 10 false z11 4.729,2.083 6.271,2.479 1.542,0.396 10 false Air Conditioning Amplifier Assembly 1.656,0.448 2.052,0.677 0.396,0.229 10 false TEA 1.635,1.406 2.094,1.656 0.458,0.25 10 false SGA

PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


e.

Check the value(s) by referring to the table below.

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Evaporator Fin Thermistor Evaporator temperature sensor (No. 1 cooler thermistor) /
Min.: -29.70°C (-21.46°F)
Max.: 59.55°C (139.19°F)
Actual evaporator temperature displayed -

OK:

The display is as specified in the Normal Condition column.


Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C




A

2.INSPECT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.INSPECT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)
a.

Remove the evaporator temperature sensor (No. 1 cooler thermistor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT EVAPORATOR TEMPERATURE SENSOR>REMOVAL).

E254486E01
0.287,0.224 0.638,0.574 0.350,0.350 10 *a 0.954,0.295 1.305,0.441 0.350,0.145 10 *b 3.963,0.282 4.313,0.428 0.350,0.145 10 *c 3.963,0.536 4.313,0.681 0.350,0.145 10 10.0 4.025,0.688 4.244,0.834 0.219,0.145 10 9.0 4.025,0.859 4.244,1.005 0.219,0.145 10 8.0 4.025,1.014 4.244,1.160 0.219,0.145 10 7.0 4.025,1.167 4.244,1.312 0.219,0.145 10 6.0 4.025,1.324 4.244,1.470 0.219,0.145 10 5.0 4.025,1.484 4.244,1.630 0.219,0.145 10 4.0 4.025,1.639 4.244,1.785 0.219,0.145 10 3.0 4.025,1.794 4.244,1.940 0.219,0.145 10 2.0 4.025,1.949 4.244,2.095 0.219,0.145 10 1.0 4.025,2.109 4.244,2.255 0.219,0.145 10 0.0 4.162,2.225 4.448,2.370 0.287,0.145 10 -10 4.75,2.225 4.880,2.370 0.130,0.145 10 0 5.243,2.225 5.470,2.370 0.228,0.145 10 10 5.757,2.225 5.985,2.370 0.228,0.145 10 20 6.299,2.225 6.526,2.370 0.228,0.145 10 30 4.162,2.366 4.448,2.512 0.287,0.145 10 (14) 4.678,2.366 4.963,2.512 0.285,0.145 10 (32) 5.216,2.366 5.491,2.512 0.274,0.145 10 (50) 5.261,2.573 5.443,2.719 0.183,0.145 10 *e 5.189,1.032 5.420,1.177 0.231,0.145 10 *d 5.721,2.366 6.000,2.512 0.280,0.145 10 (68) 6.272,2.366 6.578,2.512 0.306,0.145 10 (86) 0.608,0.686 0.942,0.352 false 4.886,1.376 5.164,1.099 false

Text in Illustration
*a Component without harness connected
(Evaporator Temperature Sensor (No. 1 Cooler Thermistor))
*b Sensing Portion
*c Resistance (kΩ) *d Allowable Range
*e Temperature (°C (°F)) - -


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -10°C (14°F) 7.30 to 9.10 kΩ
1 - 2 -5°C (23°F) 5.65 to 6.95 kΩ
1 - 2 0°C (32°F) 4.40 to 5.35 kΩ
1 - 2 5°C (41°F) 3.40 to 4.15 kΩ
1 - 2 10°C (50°F) 2.70 to 3.25 kΩ
1 - 2 15°C (59°F) 2.14 to 2.58 kΩ
1 - 2 20°C (68°F) 1.71 to 2.05 kΩ
1 - 2 25°C (77°F) 1.38 to 1.64 kΩ
1 - 2 30°C (86°F) 1.11 to 1.32 kΩ


NOTICE:
·

Hold the sensor only by its connector. Touching the sensor may change the resistance value.

·

When measuring, the sensor temperature must be the same as the ambient temperature.



HINT:

As the temperature increases, the resistance decreases (see the graph).




OK

3.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (AIR CONDITIONING AMPLIFIER - EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR))

NG

REPLACE EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)

3.INSPECT AIR CONDITIONING HARNESS ASSEMBLY (AIR CONDITIONING AMPLIFIER - EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR))
a.

Remove the air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
z11-6 (TEA) - ad-1 (TEA) Always Below 1 Ω
z11-5 (SGA) - ad-2 (SGA) Always Below 1 Ω
z11-6 (TEA) - Body ground Always 10 kΩ or higher
z11-5 (SGA) - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPLACE AIR CONDITIONING HARNESS ASSEMBLY