Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301837 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1441/41  Air Mix Damper Control Servo Motor Circuit (Passenger Side)  


DESCRIPTION

The No. 1 air conditioning radiator damper servo sub-assembly (air mix) sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 1 air conditioning radiator damper servo sub-assembly (air mix) to any position. As a result, the amount of air passing through the heater core after passing through the evaporator is adjusted, and the temperature of the air blowing is controlled.

The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.

HINT:

Confirm that no mechanical problem is present because this DTC can be stored when either a damper link or the damper is mechanically locked.


DTC No. DTC Detection Condition Trouble Area
B1441/41 Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly (air mix).
·

No. 1 air conditioning radiator damper servo sub-assembly (air mix)

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly



WIRING DIAGRAM

E229253E11
5.728,2.163 5.825,2.337 0.097,0.174 10 3 5.728,1.21 5.825,1.385 0.097,0.174 10 4 5.948,2.257 6.404,2.431 0.456,0.174 10 BUS 5.948,3.213 6.404,3.387 0.456,0.174 10 BUS G 5.511,4.06 5.754,4.235 0.242,0.174 10 z11 5.511,4.219 7.115,4.551 1.604,0.332 10 Air Conditioning Amplifier Assembly 0.485,4.074 2.542,4.597 2.057,0.523 10 No. 1 Air Conditioning Radiator Damper Servo Sub-assembly (Air Mix) 5.728,3.116 5.825,3.291 0.097,0.174 10 2 5.948,1.304 6.390,1.479 0.443,0.174 10 B BUS 3.065,4.06 4.621,4.415 1.555,0.355 10 Air Conditioning Harness Assembly

PROCEDURE

1.READ VALUE USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Operate the temperature adjustment switch.


e.

Enter the following menus: Body Electrical / Air Conditioner / Data List.


f.

Check the value(s) by referring to the table below.

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Air Mix Servo Actual Pulse (D) No. 1 air conditioning radiator damper servo sub-assembly (air mix) actual pulse / Min.: 0, Max.: 255 MAX. COLD: 6 (pulse)
MAX. HOT: 93 (pulse)
-

OK:

The display is as specified in the Normal Condition column.


Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C




A

2.PERFORM ACTIVE TEST USING GTS

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Active Test.


e.

Check the operation by referring to the table below.

Air Conditioner
Tester Display Test Part Control Range Diagnostic Note
Air Mix Servo Targ Pulse(D) No. 1 air conditioning radiator damper servo sub-assembly (air mix) pulse Min.: 0, Max.: 255 Operates between 6 to 93 pulses

OK:

Air temperature changes in accordance with each control range.




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

3.INSPECT NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX)
3.INSPECT NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX)
a.

Replace the No. 1 air conditioning radiator damper servo sub-assembly (air mix) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Result:
Result Proceed to
DTC B1441/41 is output A
DTC B1441/41 is not output B




A

4.INSPECT AIR CONDITIONING HARNESS ASSEMBLY

B

END (NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO WAS DEFECTIVE)

4.INSPECT AIR CONDITIONING HARNESS ASSEMBLY
a.

Replace the air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).

HINT:

Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Result:
Result Proceed to
DTC B1441/41 is output A
DTC B1441/41 is not output B




A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

END (AIR CONDITIONING HARNESS ASSEMBLY WAS DEFECTIVE)