The No. 2 air conditioning radiator damper servo sub-assembly (air outlet) sends pulse signals to indicate the damper position to the air conditioning amplifier assembly. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the No. 2 air conditioning radiator damper servo sub-assembly (air outlet) to any position, which controls the air outlet switching.
The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.
Confirm that no mechanical problem is present because this DTC can be stored when either a damper link or the damper is mechanically locked.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1443/43 | Air outlet damper position sensor value does not change even if air conditioning amplifier assembly operates No. 2 air conditioning radiator damper servo sub-assembly (air outlet). | ·
No. 2 air conditioning radiator damper servo sub-assembly (air outlet) ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Operate the MODE switch.
Enter the following menus: Body Electrical / Air Conditioner / Data List.
Check the value(s) by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Outlet Servo Actu Pulse (D) | No. 2 air conditioning radiator damper servo sub-assembly (air outlet) actual pulse / Min.: 0, Max.: 255 | FACE: 47 (pulse)
B/L: 37 (pulse) FOOT: 17 to 23 (pulse) FOOT/DEF: 9 (pulse) DEF: 5 (pulse) |
- |
The display is as specified in the Normal Condition column.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC) | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Rage | Diagnostic Note |
|---|---|---|---|
| Air Outlet Servo Pulse (D) | No. 2 air conditioning radiator damper servo sub-assembly (air outlet) pulse | Min.: 0, Max.: 255 | Operates between 5 to 47 pulses |
Air flow position changes in accordance with each control range.
OK
NG
Replace the No. 2 air conditioning radiator damper servo sub-assembly (air outlet) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1443/43 is output | A |
| DTC B1443/43 is not output | B |
A
B
Replace the air conditioning harness assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY).
Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.
Check for the DTC.
| Result | Proceed to |
|---|---|
| DTC B1443/43 is output | A |
| DTC B1443/43 is not output | B |
A
B