Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301837 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the power switch is turned off. The power is used for DTC memory etc.

WIRING DIAGRAM

B468306E02
0.219,0.615 1.615,0.885 1.396,0.271 10 false from Auxiliary Battery 2.5,0.792 3.177,1.125 0.677,0.333 10 false ECU-B3 4.906,0.635 5.208,0.938 0.302,0.302 10 false B 4.906,1.333 5.208,1.635 0.302,0.302 10 false GND 4.688,1.844 4.99,2.146 0.302,0.302 10 false L17 4.677,2.01 6.219,2.396 1.542,0.385 10 false Air Conditioning Amplifier Assembly 4.615,1.219 4.917,1.521 0.302,0.302 10 false 14 4.615,0.531 4.917,0.833 0.302,0.302 10 false 21

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - POWER SOURCE)
a.

Disconnect the L17 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
L17-21 (B) - Body ground Power switch off 11 to 14 V




OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L17-14 (GND) - Body ground Always Below 1 Ω




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR