Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR › 2012.03–2020.08
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301845 COMPRESSOR A

HEATING / AIR CONDITIONING  COMPRESSOR  REMOVAL  


PROCEDURE

Hide 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFC-134a(R134a))

Hide 2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (for HFO-1234yf(R1234yf))

Hide 51441 8.REMOVE NO. 1 ENGINE UNDER COVER

Hide 88711 9.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

a.
E253604

Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor with motor assembly.


b.

Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88712 10.DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE

a.
E253605

Remove the bolt and disconnect the No. 1 cooler refrigerant suction hose from the compressor with motor assembly.


b.

Remove the O-ring from the No. 1 cooler refrigerant suction hose.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88370 11.REMOVE COMPRESSOR WITH MOTOR ASSEMBLY

a.
E250913E02
1.344,2.5 1.646,2.229 false 1.688,2.094 1.844,2.24 0.156,0.146 10 false *1 1.365,1.438 1.656,1.583 0.292,0.146 10 true <B> 2.531,1.167 2.823,1.406 0.292,0.24 10 true <A>

Using a screwdriver, slide the green-colored lock of the connector <A> in the direction indicated by the arrow in the illustration to release it and disconnect the connector.

Text in Illustration
*1 Green-colored Lock

CAUTION:

Make sure to wear insulated gloves.


NOTICE:

Insulate the removed terminals and connector with insulating tape.



b.

Disconnect the connector <B>.


c.
E223836

Remove the 2 bolts and nut.


d.
E223837

Using an E8 "TORX" socket, remove the stud bolt and compressor with motor assembly.

HINT:

Remove the compressor with motor assembly from the vehicle with the stud bolt remaining in the compressor with motor assembly.