Home › Vehicle Interior › HEATING / AIR CONDITIONING › CONDENSER
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301846 CONDENSER A

HEATING / AIR CONDITIONING  CONDENSER  REASSEMBLY  


PROCEDURE

Hide 88474 1.INSTALL COOLER DRYER

a.
E189084

Using pliers, install a new cooler dryer to the modulator.


b.

for Type A:

i.
E101932

Apply a sufficient amount of compressor oil to the O-ring and the fitting surfaces of a new cap.

Compressor oil:

ND-OIL 11 or equivalent


NOTICE:

Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.




c.

for Type B:

i.
E363464

Apply a sufficient amount of compressor oil to the 3 O-rings and the fitting surfaces of a new cap.

Compressor oil:

ND-OIL 11 or equivalent


NOTICE:

Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.




d.
E189083E02
1.742,0.411 1.895,0.551 0.154,0.140 10 *1 1.728,0.491 1.493,0.909 false

Using a 14 mm straight hexagon wrench, install the cap to the modulator.

Text in Illustration
*1 14 mm Straight Hexagon Wrench

Torque:
for Type A : 2.9 N*m (30 kgf*cm, 26 in.*lbf)
for Type B : 4.0 N*m (41 kgf*cm, 35 in.*lbf)

NOTICE:
·

Keep the O-ring and O-ring fitting surfaces clean from dirt or any foreign objects.

·

Do not use any compressor oil other than ND-OIL 11 or equivalent. If any compressor oil other than ND-OIL 11 or equivalent is used, compressor motor insulation performance may decrease, resulting in a leakage of electric power.




Hide 88467 2.INSTALL NO. 1 COOLER CONDENSER CUSHION

a.

for RH Side:

i.
E189082

Install the No. 1 cooler condenser cushion as shown in the illustration.



b.

for LH Side:

i.
E189080

Install the No. 1 cooler condenser cushion as shown in the illustration.