Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE
RM2070E _58 Vehicle Interior _061948 INTERIOR PANELS / TRIM _0301861 ROOF SUNSHADE A

INTERIOR PANELS / TRIM  ROOF SUNSHADE  DISASSEMBLY  


PROCEDURE

Hide 63652A 1.REMOVE NO. 1 SUNSHADE GARNISH LH

a.
B284958

Remove the 2 screws and No. 1 sunshade garnish LH.


Hide 63651A 2.REMOVE NO. 1 SUNSHADE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 63654A 3.REMOVE NO. 2 SUNSHADE GARNISH LH

a.
B284959

Remove the 2 screws and No. 2 sunshade garnish LH.


Hide 63653A 4.REMOVE NO. 2 SUNSHADE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 63514A 5.REMOVE CONNECTOR WIRE

a.
B274345

Disconnect the connector.


b.

Disengage the 3 clamps and remove the connector wire.


Hide 63260H 6.REMOVE SLIDING ROOF DRIVE GEAR ASSEMBLY

a.
B274346

Remove the 2 bolts and sliding roof drive gear assembly.


Hide 63306 7.REMOVE SUNSHADE TRIM SUB-ASSEMBLY

a.
B274348

Remove the 8 screws.


b.

Using a T20 "TORX" socket wrench, remove the 4 "TORX" screws and sunshade trim sub-assembly from the slide roof rail sub-assembly.


Hide 63303 8.REMOVE NO. 2 SUNSHADE TRIM SUB-ASSEMBLY

HINT:

Perform this procedure only when the No. 2 sunshade trim sub-assembly needs to be replaced.


a.
B286493E03
2.552,0.406 2.729,0.573 false 2.635,0.573 2.844,0.76 0.208,0.188 10 true *1

Insert a 2.5 mm hexagon wrench into the circular hole of the No. 2 sunshade trim assembly as shown in the illustration.

Text in Illustration
*1 Circular Hole

NOTICE:

Make sure that the hexagon wrench does not fall out when removing the No. 2 sunshade trim assembly.



b.
B286495E03
1.823,3.927 2.125,4.021 false 0.604,1.104 0.688,0.813 true 0.708,3.313 0.792,3.01 true 2.313,4.188 2.51,4.354 0.198,0.167 10 false (1) 2.219,3.385 2.417,3.552 0.198,0.167 10 true (2) 1.656,3.844 1.813,3.99 0.156,0.146 10 true *1 0.5,1.115 0.656,1.26 0.156,0.146 10 false *3 0.604,3.323 0.76,3.469 0.156,0.146 10 false *2

Using a screwdriver, press the pin in the direction indicated by the arrow (1) shown in the illustration.

Text in Illustration
*1 Protective Tape
*2 Pin
*3 Guide

HINT:

Tape the screw driver tip before use.



c.

Pull the No. 2 sunshade trim sub-assembly in the direction indicated by the arrow (2) shown in the illustration.


d.

Disengage the guide and remove the No. 2 sunshade trim sub-assembly.

HINT:

Use the same procedure for the other side sunshade trim.