81260A
1.INSPECT ROOF SUNSHADE SWITCH (MAP LIGHT ASSEMBLY)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (CLS) - 15 (GND1) | CLOSE switch is pressed | Below 1 Ω |
| 8 (CLS) - 15 (GND1) | CLOSE switch is not pressed | 10 kΩ or higher |
| 9 (OPN) - 15 (GND1) | OPEN switch is pressed | Below 1 Ω |
| 9 (OPN) - 15 (GND1) | OPEN switch is not pressed | 10 kΩ or higher |
| *a | Component without harness connected
(Roof Sunshade Switch (Map Light Assembly)) |
If the result is not as specified, the roof sunshade switch (map light assembly) may be malfunctioning.