Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE SYSTEM
RM2070E _58 Vehicle Interior _061948 INTERIOR PANELS / TRIM _0301863 ROOF SUNSHADE SYSTEM U

INTERIOR PANELS / TRIM  ROOF SUNSHADE SYSTEM  TERMINALS OF ECU  


CHECK ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)


a.

Disconnect the z21 ECU connector.

U154529E03
3.469,0.104 3.781,0.333 0.313,0.229 10 false z21


b.

Measure the resistance and voltage according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
z21-1 (B) - z21-2 (E) R-W - B-W +B Power supply Power switch off 11 to 14 V
z21-5 (IG) - z21-2 (E) R - B-W Power switch power supply Power switch off Below 1 V
z21-5 (IG) - z21-2 (E) R - B-W Power switch power supply Power switch on (IG) 11 to 14 V
z21-2 (E) - Body ground B-W - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the z21 ECU connector.


d.

Measure the voltage according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
z21-7 (OPN) - z21-2 (E) G - B-W Roof sunshade motor open Power switch on (IG), OPEN switch on Below 1 V
z21-7 (OPN) - z21-2 (E) G - B-W Roof sunshade motor open Power switch on (IG), OPEN switch off 11 to 14 V
z21-9 (CLS) - z21-2 (E) L - B-W Roof sunshade motor close Power switch on (IG), CLOSE switch on Below 1 V
z21-9 (CLS) - z21-2 (E) L - B-W Roof sunshade motor close Power switch on (IG), CLOSE switch off 11 to 14 V

If the result is not as specified, the roof sunshade ECU (sliding roof drive gear assembly) may have a malfunction.