Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF SUNSHADE SYSTEM
RM2070E _58 Vehicle Interior _061948 INTERIOR PANELS / TRIM _0301863 ROOF SUNSHADE SYSTEM C

INTERIOR PANELS / TRIM  ROOF SUNSHADE SYSTEM  B2343  Position Initialization Incomplete  


DESCRIPTION

This DTC is output when the roof sunshade ECU (sliding roof drive gear assembly) has not been initialized.

DTC Code DTC Detection Condition Trouble Area
B2343 Roof sunshade ECU (sliding roof drive gear assembly) has not been initialized. Roof sunshade ECU (Sliding roof drive gear assembly)

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:
·

When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.

·

When the roof sunshade ECU (sliding roof drive gear assembly) is replaced or removed and reinstalled, it requires initialization (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION).



PROCEDURE

1.INITIALIZE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)
a.

Check that the roof sunshade ECU (sliding roof drive gear assembly) can be initialized (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>INITIALIZATION).

OK:

Roof sunshade ECU (sliding roof drive gear assembly) can be initialized.




OK

2.CHECK ROOF SUNSHADE OPERATION

NG

REPLACE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)

2.CHECK ROOF SUNSHADE OPERATION
a.

Check the roof sunshade auto operation (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF SUNSHADE SYSTEM>OPERATION CHECK).

OK:

Auto operation operates normally.




OK

3.CHECK DTC OUTPUT

NG

REPLACE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)

3.CHECK DTC OUTPUT

b.

Recheck for DTCs.

OK:

DTC B2343 is not output.




OK

END

NG

REPLACE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)