Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2012.03–2013.08
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301864 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)  


DESCRIPTION

If a door glass or a power window regulator motor assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.

HINT:

This symptom may occur for any of the windows.


CAUTION / NOTICE / HINT

NOTICE:
·

If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).

·

If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
a.

Initialize the power window regulator motor assembly (applicable location) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



NEXT

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION))
2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION))
a.

Check that all power windows move when the auto up and down functions of the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH, RH doors) are operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Auto up and down functions are normal (applicable location).




OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
a.

Remove the window regulator.


b.

Install the window glass onto the door glass run.


c.

Check if the door window regulator operates smoothly.


d.

Check that the window glass slides smoothly when sliding it up by hand.

OK:

Door window glass slides smoothly.


Result:
Result Proceed to
NG A
OK (Driver door power window) B
OK (Front passenger door power window) B
OK (Rear LH door power window) C
OK (Rear RH door power window) C


HINT:

Ensure the following:

·

The window glass fits with the glass run without improper contact or deformation.

·

Foreign objects are not caught in the glass run.



CAUTION:

Perform initialization again.




A

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FIT OR REPLACE PARTS)

B

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door)

C

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door)