This symptom may occur for any of the windows.
The jam protection function operates within a specified range during the manual up or auto up operation.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Initialize the power window regulator motor assembly (applicable location) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check if the power window auto up and down functions operate normally (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Auto up and down functions are normal.
OK
NG
Check if the jam protection function operates normally for the applicable power window.
The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
Jam protection function operates normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (Driver door power window) | B |
| NG (Front passenger door power window) | B |
| NG (Rear LH door power window) | C |
| NG (Rear RH door power window) | C |
A
B
C