If the manual up and down functions operate normally but the auto up and down functions do not, the fail-safe mode may be functioning.
If power window initialization (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION) has not been performed, the auto up and down functions will not operate.
If the pulse sensor built into the power window regulator motor assembly (for rear RH door) malfunctions, the power window control system enters fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the rear power window regulator switch assembly (for RH door) at the auto up position, and opened manually by pushing down the rear power window regulator switch assembly (for RH door).
The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
If the power window regulator motor assembly (for rear RH door) has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / RR-Door Motor / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| RR Door P/W Auto SW | Rear RH door power window auto switch signal / OFF or ON | OFF: Rear RH power window auto switch not operated
ON: Rear RH power window auto switch operated |
- |
On the GTS screen, ON or OFF is displayed accordingly.
OK
NG
Initialize the power window regulator motor assembly (for rear RH door) (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
NEXT
Check that the rear RH door power window moves when the auto up and down functions of the rear power window regulator switch assembly (for RH door) are operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).
Rear RH door auto up and down functions are normal.
OK
NG
Remove the rear power window regulator switch assembly (for RH door) (See page Vehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (AUTO) - 1 (GND) | Auto up or auto down position | Below 1 Ω |
| *a | Component without harness connected
(Rear Power Window Regulator Switch Assembly (for RH Door)) |
OK
NG
Disconnect the P4 power window regulator motor assembly (for rear RH door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P2-8 (AUTO) - P4-4 (AUTO) | Always | Below 1 Ω |
| P2-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| P4-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
OK
NG