Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301867 REAR POWER WINDOW SWITCH G

WINDOW / GLASS  REAR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810D 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for LH Side)

a.
B203473E29
0.623,1.607 0.776,1.750 0.153,0.144 10 *a 0.059,2.626 0.468,2.766 0.410,0.139 10 AUTO 1.716,2.439 2.047,2.581 0.331,0.142 10 GND 0.227,3.045 0.694,3.191 0.467,0.146 10 DOWN 1.445,3.045 1.658,3.186 0.213,0.141 10 UP 0.806,2.71 0.55,2.71 false 1.699,2.515 1.413,2.515 false 1.201,2.785 1.201,3.128 1.201,3.128 1.416,3.128 false 1.004,2.785 1.004,3.128 1.004,3.128 0.789,3.128 false

Check the switch function.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (UP) - 1 (GND) Auto up or up position Below 1 Ω
7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω
8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω
6 (UP) - 1 (GND) Free 10 kΩ or higher
7 (DOWN) - 1 (GND) Free 10 kΩ or higher
8 (AUTO) - 1 (GND) Free 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly (for LH Door))

If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).



b.
B203473E32
0.623,1.611 0.776,1.755 0.153,0.144 10 *a 1.603,0.013 1.756,0.156 0.153,0.144 10 *b 1.716,2.444 2.047,2.586 0.331,0.142 10 GND 1.699,2.519 1.413,2.519 false 0.135,2.444 0.431,2.586 0.296,0.142 10 LED 0.788,2.519 0.502,2.519 false 2.314,0.212 2.314,0.086 2.314,0.086 1.781,0.086 false

Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → 4 (LED)
Auxiliary battery negative (-) → 1 (GND)
LED illuminates


Text in Illustration
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly (for LH door))
*b LED

If the result is not as specified, replace the rear power window regulator switch assembly (for LH door).



Hide 84810D 2.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (for RH Side)

a.
B203473E29
0.623,1.607 0.776,1.750 0.153,0.144 10 *a 0.059,2.626 0.468,2.766 0.410,0.139 10 AUTO 1.716,2.439 2.047,2.581 0.331,0.142 10 GND 0.227,3.045 0.694,3.191 0.467,0.146 10 DOWN 1.445,3.045 1.658,3.186 0.213,0.141 10 UP 0.806,2.71 0.55,2.71 false 1.699,2.515 1.413,2.515 false 1.201,2.785 1.201,3.128 1.201,3.128 1.416,3.128 false 1.004,2.785 1.004,3.128 1.004,3.128 0.789,3.128 false

Check the switch function.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (UP) - 1 (GND) Auto up or up position Below 1 Ω
7 (DOWN) - 1 (GND) Auto down or down position Below 1 Ω
8 (AUTO) - 1 (GND) Auto up or auto down position Below 1 Ω
6 (UP) - 1 (GND) Free 10 kΩ or higher
7 (DOWN) - 1 (GND) Free 10 kΩ or higher
8 (AUTO) - 1 (GND) Free 10 kΩ or higher


Text in Illustration
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly (for RH Door))

If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).



b.
B203473E32
0.623,1.611 0.776,1.755 0.153,0.144 10 *a 1.603,0.013 1.756,0.156 0.153,0.144 10 *b 1.716,2.444 2.047,2.586 0.331,0.142 10 GND 1.699,2.519 1.413,2.519 false 0.135,2.444 0.431,2.586 0.296,0.142 10 LED 0.788,2.519 0.502,2.519 false 2.314,0.212 2.314,0.086 2.314,0.086 1.781,0.086 false

Check that the LED illuminates.

i.

Apply auxiliary battery voltage to the rear power window regulator switch assembly and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Auxiliary battery positive (+) → 4 (LED)
Auxiliary battery negative (-) → 1 (GND)
LED illuminates


Text in Illustration
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly (for RH Door))
*b LED

If the result is not as specified, replace the rear power window regulator switch assembly (for RH door).