Home › Vehicle Exterior › WINDOW / GLASS › FRONT SIDE FIX WINDOW GLASS › 2014.11–2016.05
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301871 FRONT SIDE FIX WINDOW GLASS A

WINDOW / GLASS  FRONT SIDE FIX WINDOW GLASS  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 62312B 1.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.

Remove the front part of the front door opening trim weatherstrip to the extent that allows removal of the front pillar garnish.


Hide 62120B 4.REMOVE FRONT SIDE FIX WINDOW ASSEMBLY

a.
B291621E01
0.948,0.382 1.105,0.531 0.157,0.149 10 *1 1.647,0.752 1.136,0.466 false

Apply protective tape to the installation position of the front side fix window assembly on the vehicle body.

Text in Illustration
*1 Protective Tape


b.
B291622E01
0.741,0.562 0.899,0.711 0.157,0.149 10 *1 1.476,0.843 0.925,0.644 false

Pass a piano wire between the interior vehicle body and glass from the interior as shown in the illustration.

HINT:

Do not allow the piano wire to interfere with the clips.


Text in Illustration
*1 Piano Wire


c.

Tie both wire ends to wooden blocks or similar objects that can serve as handles.

NOTICE:

When separating the front side fix window assembly from the vehicle, be careful not to damage the paint or interior and exterior ornaments.



d.

Cut off the adhesive by pulling the piano wire around the front side fix window assembly.

NOTICE:

Leave as much adhesive on the vehicle body as possible when cutting through the adhesive.



e.
B291623

Disengage the 3 clips.


f.

Using suction cups, remove the glass.

NOTICE:

Be careful not to drop the glass.



Hide 5.CLEAN VEHICLE BODY

a.
B106081E36
0.49,1.302 0.771,0.729 0.771,0.729 0.948,0.729 false 2.281,1.438 2.563,0.74 2.563,0.74 2.729,0.74 false 2.427,1.615 2.427,1.792 false 0.802,1.563 0.802,1.75 false 1,0.656 1.24,0.854 0.24,0.198 10 false *1 2.781,0.667 3.021,0.865 0.24,0.198 10 false *1 0.74,1.802 0.979,2 0.24,0.198 10 false *2 2.365,1.833 2.604,2.031 0.24,0.198 10 false *2

Clean and shape the contact surfaces of the vehicle body.

Text in Illustration
*1 Adhesive
*2 Vehicle Body

i.

Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.

NOTICE:

Be careful not to damage the vehicle body.


HINT:

Leave as much adhesive on the vehicle body as possible.




b.

Clean the contact surfaces of the vehicle body with a piece of cloth saturated with cleaner.

HINT:

Even if all the adhesive has been removed, clean the vehicle body.