Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER WIRE
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301875 WINDOW DEFOGGER WIRE A

WINDOW / GLASS  WINDOW DEFOGGER WIRE  REPAIR  


PROCEDURE

Hide 68131 1.REPAIR REAR WINDOW DEFOGGER WIRE (BACK DOOR GLASS)

B106758E30
1.052,0.573 0.5,1.083 0.5,1.083 1.104,1.01 false 1.719,0.958 1.719,1.354 false 2.833,0.875 2.833,1.104 false 1.646,1.375 1.99,1.708 0.344,0.333 10 false *a 0.365,1.115 0.635,1.375 0.271,0.26 10 false *1 2.76,1.135 3.063,1.49 0.302,0.354 10 false *2

Text in Illustration
*1 Masking Tape
*2 Broken Wire
*a Repair Point

a.

Clean the broken wire tips with a grease, wax and silicone remover.


b.

Place masking tape along both sides of the wire.


c.
B106759

Thoroughly mix the repair agent (Dupont paste No. 4817 or equivalent).


d.

Using a fine tip brush, apply a small amount of the agent to the wire.


e.

After a few minutes, remove the masking tape.

NOTICE:

Do not use the rear window defogger for at least 24 hours after performing the repair.