Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR NO. 2 SEAT ASSEMBLY
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
64910J
7.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
67935A
8.REMOVE BACK DOOR SCUFF PLATE
67918A
9.REMOVE REAR DOOR SCUFF PLATE
62332A
10.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
Disconnect the rear door opening trim weatherstrip.
64721G
11.REMOVE NO. 1 DECK TRIM COVER
58460D
12.REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY
64713F
13.REMOVE FRONT DECK SIDE TRIM COVER
55548C
14.REMOVE NO. 2 CUP HOLDER (for LH Side)
55548C
15.REMOVE NO. 1 CUP HOLDER (for RH Side)
73370C
16.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY
73570
17.DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY (for Lower Side)
81250
18.REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)
64740C
19.REMOVE DECK TRIM SIDE PANEL ASSEMBLY
62480A
20.REMOVE ROOF SIDE INNER GARNISH ASSEMBLY
62720A
21.REMOVE QUARTER WINDOW ASSEMBLY
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *1 | Protective Tape |
Pass a piano wire between the vehicle body and glass from the interior as shown in the illustration.
Ensure not to interfere with the clips when passing the piano wire.
| *1 | Piano Wire |
Tie both wire ends to wooden blocks or similar objects that can serve as handles.
When separating the quarter window assembly from the vehicle, be careful not to damage the paint or interior and exterior ornaments.
Cut off the adhesive by pulling the piano wire around the quarter window assembly.
Leave as much adhesive on the vehicle body as possible when cutting through the adhesive.
Disengage the 3 clips.
Using suction cups, remove the glass.
Be careful not to drop the glass.
22.CLEAN VEHICLE BODY
Clean and shape the contact surfaces of the vehicle body.
| *1 | Adhesive |
| *2 | Vehicle Body |
Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.
Be careful not to damage the vehicle body.
Leave as much adhesive on the vehicle body as possible.
Clean the contact surfaces of the vehicle body with a piece of cloth saturated with cleaner.
Even if all the adhesive has been removed, clean the vehicle body.